MK Products Advanced Color Logic User Manual
Page 51
Advanced Color Logic Owner’s Manual - Page 44
Modifying Procedures, con’t.
The third tab in MK Edit is Advanced. It allows for further modifications to an overall weld procedure
(see below). This includes information such as adjusting the pre-motor time and speed, number of
tacks, and degree of start position. You can also select the following options:
Initial Home: Forces the weldhead to move to home position before each weld.
Final Home: Forces the weldhead to move to home postion after each weld.
Repeat Weld
: Doesn’t require user confirmation at the end of each weld. After a short delay it’s
ready to start the next weld.
Data Monitor
: Enables weld performance checking to make sure that each weld is within predefined
limits from Data Monitoring table.
There are also options for printing and saving the weld log.