MK Products Advanced Color Logic - Manual (Page 49)

Advanced Color Logic Owner’s Manual - Page 42
Modifying Procedures
If you decide to make changes to an existing procedure, clicking on the Weld Procedure icon will
open up the window that allows for modifications.
Known as MK Edit, this window consists of three tabs, each allowing for the welder to input
additional information. The first tab, Weld Record, allows modification of weld level parameters. After
selecting a level (with the mouse or arrow keys), you can then click and drag the mouse within the tube to
mark the level length and it will change the Ends At value for the selected level (Figure 7).
Clicking on any other parameter in the table also allows it to be changed (Figure 8).
You can also make changes to the ID strings, located at the top right of the window. Below these fields you
can also adjust the max scale, pre and post purge seconds, strike current and number of tacks. For more
information on the significance of these changes, please consult your owner’s manual.
Figure 8
Figure 7
Click and drag mouse
to adjust level length
Changes from mouse
are also reflected here
Click in any field
to make changes