Warranty, Safety/caution notice – Measurement Computing TempBook rev.3.0 User Manual
Page 2
© 1997 by IOtech, Inc.
Part No.
TempBook/66-901,
Rev.
3.0
Printed in the United States of America
Warranty
Your IOtech warranty is as stated on the product warranty card. You may contact IOtech by phone,
fax machine, or e-mail in regard to warranty-related issues.
Phone: (440) 439-4091, fax: (440) 439-4093, e-mail:
Limitation of Liability
IOtech cannot be held liable for any damages resulting from the use or misuse of this product.
Copyright and Trademark Notice
© ® ™ All IOtech documentation, software, and circuit boards are copyrighted with all rights reserved by
IOtech. No part of this product may be copied, reproduced or transmitted by any mechanical,
photographic, electronic, or other method without prior written consent of IOtech, Inc. TempBook,
TempView, DaqView, and related product names are trademarks of IOtech, Inc. Other product names
are trademarks of their respective holders.
FCC Statement
IOtech devices emit radio frequency energy in levels compliant with Federal Communications
Commission rules (Part 15) for Class A devices. The following booklet, prepared by the FCC, may be
helpful: How To Identify and Resolve Radio-TV Interference Problems (stock no. 044-000-00345-4).
The booklet is available from the US Government Printing Office, Washington, DC 20402
CE Notice
Many IOtech products now carry the CE marker to indicate they comply with safety and emissions
standards as regulated by the European Community. Such products are shipped with a Declaration of
Conformity stating which specifications and operating conditions apply.
Safety/Caution Notice
The TempBook contains no user-serviceable parts other than expressed in this manual; refer all service
to qualified personnel. Perform system connections and all service (but not calibration) with the power
off to the device serviced and to all connected equipment. Using this equipment in ways other than
described in this manual can present serious safety hazards or cause equipment damage.
This warning symbol is used in this manual or on the equipment to warn of possible injury or death
from electrical shock under noted conditions.
This caution symbol is used to warn of possible personal injury or equipment damage under noted
conditions. Follow all safety standards of professional practice and recommendations in the manual.
This ESD caution symbol is used to urge proper handling of equipment or components sensitive to
damage from electrostatic discharge. Handling guidelines include properly grounded mats and wrist
straps, ESD bags and cartons, and related procedures.
Calibration Notice
IOtech products are factory-calibrated to published specifications, and associated trimpots have been
sealed in the calibrated position. Re-calibration in the warranty period is the responsibility of the user
and is covered under warranty at IOtech’s discretion.
Quality Notice
Certified to ISO 9001 standards since 1996, IOtech applies tests and procedures to assure the highest
quality in all aspects of our products. Prior to shipment, we thoroughly test the products and review the
documentation. In a spirit of continuous improvement, IOtech welcomes your suggestions.