beautypg.com

Appendix b - tcp/ip and resource tests, Appendix b – tcp/ip and resource tests b, Before you run a test – Measurement Computing IOtech 640 Series User Manual

Page 91: How to run the tcp/ip test

background image

Appendix B

907493

TCP/IP and Resource Tests for 640 & 650 Series B-1

Appendix B – TCP/IP and Resource Tests B

Before you run a test

Before testing the system, make sure the device has been properly installed and powered-on. Make sure all
cables are properly and securely connected.

When testing a 640 or 650 Series device, if the unit does not respond within 30 seconds
perform the following steps:

1) reboot the system
2) upon power-up, re-open the Daq* Configuration
applet
3) select another configuration setting
4) reinitiate the test

How to run the TCP/IP Test

(The TCP/IP test is for Ethernet devices only)

The TCP/IP (Transmission Control Protocol/Internet Protocol) test is for Ethernet devices only. The test is
accessed and initiated as follows.

a. Open the Control Panel by navigating from the Windows’ Desktop as follows:

Start Menu

Settings Control Panel

b. From the Control Panel, double-click the Daq Configuration icon.

c. Double-click on the 640e or 650e from the Device Inventory configuration tree.

d. Click the “Test Hardware” tab.

e. Click the <TCP/IP Test> button.

The Test Hardware Tab