Step 6 – Measurement Computing IOtech 640 Series User Manual
Page 32

4-10 Configuring Ethernet Models 640e & 650e
878893
640 & 650 Series
STEP 6 -
Configure Device Network Settings using DaqIPConfig
Applies only to a LAN (Local Area Network), which has a no DHCP server.
If using a LAN (Local Area Network), which has a DHCP server, skip this section and continue
with STEP 7 - Configure and Test the System using the Daq Configuration Applet (page 4-11).
Multiple devices on a LAN are each identified by their unique (device-specific) serial number.
Ensure that the serial number displayed for the unit [being configured] agrees with the serial
number on the MAC label, located on the rear panel of the device.
The DaqIPConfig applet, designed for 32-bit Windows /2000/XP systems. DaqIPConfig allows you to change the
IP address of a device to match the address of a host computer. The applet is located in the program group for the
associated device and can be accessed from the Windows Desktop via the start menu.
Reference Note:
Appendix A contains general information regarding how to use the Daq Configuration Applet.
1. Locate the DaqIPConfig Applet.
Locate the DaqIPConfig applet by navigating from the
Windows’ Desktop as follows:
Start Menu
⇒ Programs
⇒ IOtech Application Software
; for example:
IOtech eZ-Analyst Software, IOtech eZ-TOMAS Software, etc.
⇒ DaqIPConfig
2. Open the DaqIPConfig Applet.
Click on the DaqIPConfig selection to open the applet.
3. Select the Device Type that is to have the address
change.
Note: In the figure to the right 650e is selected.
4. Set the internet protocol (TCP/IP) settings to be
compatible with host computer.
(a) Select the radio button labeled “Use the following IP
address.”
(b) Enter the new internet protocol settings. If needed,
consult your network administrator for acceptable
numbers.
Do not set the TCP/IP to the
computer’s IP address.
(c) Click the
5. Reboot the device.
The new IP address will not take affect until the device has been powered-off, then powered back on.
6. Repeat steps 3, 4, and 5 for other devices in the system.
After configuring the network settings for all devices, proceed to Step 7.
DaqIPConfig