Measurement Computing IOtech 640 Series - Manual (Page 90)

A-4 Using the Daq Configuration Applet 907493 Appendix A
To set the properties of a 640e or 650e on a LAN with DHCP server:
a. Enter the base 10 version of the serial number of the 640e or 650e. The number is located on
the MAC label on the bottom of the unit.
b. Get the IP address of the device from your network administrator. The network administrator
will need the unit powered-on and connected to the network. The administrator will also
need the MAC address label’s hexadecimal number (the label’s bottom number).
c. Select the “Manual IP Setting” radio button.
d. In the IP Address field, enter the IP address obtained from your network administrator.
To test the connection:
a. Click the “Test Hardware” tab.
b. Click the <Resource Test> button.
c. Perform a TCP/IP test per Appendix B.