Measurement Computing LGR-5320 Series - Manual (Page 8)

8
Chapter 2
Installing a LGR-5320 Series Device
What comes with your shipment?
Verify that the following hardware components are included in the shipment:
Hardware
 LGR-5320 Series device – LGR-5325, LGR-5327, or LGR-5329
 USB cable (2-meter length)
 SD card
 9 VDC, 1 A external power supply for use when LGR-5320 Series is not powered through the screw
terminals
Software
DAQLog CD
Optional components
ACC-202 Din-rail kit
Accessory for mounting a LGR-5320 Series device to a standard DIN rail. Use the thread-forming screws to
attach the DIN rail clip to your device.
Documentation
In addition to this hardware user's guide, a DAQLog Quick Start is included with the
LGR-5320 Series shipment. This booklet provides instructions about installing the software and logging data.
Unpacking
As with any electronic device, take care while handling to avoid damage from static electricity. Before
removing the LGR-5320 Series device from its packaging, ground yourself using a wrist strap or touch either
the computer chassis or other grounded object to eliminate any stored static charge.
If the device is damaged, notify Measurement Computing Corporation immediately by phone, fax, or email.
 Knowledgebase: kb.mccdaq.com
 Phone: 508-946-5100 and follow the instructions for reaching Tech Support
 Fax: 508-946-9500 to the attention of Tech Support
 Email:
[email protected]
For international customers, contact your local distributor. Refer to the International Distributors section on our
web site at
www.mccdaq.com/International .
Thread-forming
screws