Measurement Computing DAQFlex User Guide - Manual (Page 95)

DAQFlex Software User's Guide FlexTest Utility
95
The Ai Self Calibration window opens.
3.
Click the Start button to start calibrating the analog inputs.
The progress bar updates as the operation progresses. When calibration is done the window
displays
Complete
.
4.
Click
OK
to close the window.
Calibrating analog outputs
To calibrate a device's analog outputs, do the following:
1.
Select the AO tab .
2.
Click the
Calibrate
button.
The
Ao Self Calibration
window opens.
3.
Click the Start button to start calibrating the analog outputs.
The progress bar updates as the operation progresses. When calibration is done the window
displays
Complete
.
4.
Click OK to close the window.
DAQFlex message reference
Refer to the DAQFlex Message Reference chapter on page 31 for the supported DAQFlex API messages.
Note: FlexTest cannot be run at the same time as the DAQFlex Firmware Loader utility
(DAQFlexFWLoader.exe).