Measurement Computing DAQFlex User Guide - Manual (Page 103)

DAQFlex Software User's Guide Hardware Reference – USB-1208FS-Plus
103
Component Supported
Property/Command Set/Get Supported Values
RANGE Set/Get BIP20V, BIP10V, BIP5V, BIP4V, BIP2PT5V,
BIP2V, BIP1PT25V, BIP1V (differential
mode)
BIP10V (single-ended mode)
RANGE{ch}
SAMPLES Set/Get 0 to N
(0 = continuous scan; N = 32-bit)
SCALE Set/Get ENABLE, DISABLE
START
STATUS Get IDLE, RUNNING, OVERRUN
STOP
TRIG Set/Get ENABLE, DISABLE
XFRMODE Set/Get BLOCKIO, SINGLEIO
AITRIG
REARM Set/Get ENABLE/DISABLE
TYPE Set/Get EDGE/RISING, EDGE/FALLING
LEVEL/HIGH, LEVEL/LOW
AO
Get 2 (number of analog output channels)
RES Get U12
SCALE Set/Get ENABLE, DISABLE
AO{ch}
RANGE Get UNI5V
VALUE Set 0 to 4095
0 to 4.99878 when SCALE is enabled
AOSCAN
BUFSIZE Set/Get
COUNT Get
HIGHCHAN Set/Get 0 to 1
INDEX Get
LOWCHAN Set/Get 0 to 1
RATE Set/Get 0.01 S/s to 50 kS/s
SAMPLES Set/Get 0 to N
(0 = continuous scan; N = 32-bit)
SCALE Set/Get ENABLE, DISABLE
START Set
STATUS Get IDLE, RUNNING, UNDERRUN
STOP Set
CTR
Get 1 (number of counter channels)
CTR{ch}
START Set
STOP Set
VALUE Get 0 to 4,294,967,295
Set 0 (resets the counter to 0)