Measurement Computing DAQFlex User Guide - Manual (Page 122)

DAQFlex Software User's Guide Hardware Reference – USB-7204
122
USB-7204
Use the components below to set or get device properties.
Component
Supported
Property/Command Set/Get Supported Values
AI
Get Number of analog input channels
CAL Set/Get ENABLE, DISABLE
CHMODE Set/Get SE, DIFF
SCALE Set/Get ENABLE, DISABLE
AI{ch}
OFFSET Get 4-byte floating point numeric
RANGE Set/Get BIP20V, BIP10V, BIP5V, BIP4V, BIP2PT5V,
BIP2V, BIP1PT25V, BIP1V
SLOPE Get 4-byte floating point numeric
VALUE Get Unsigned integer numeric
VALUE/{format} Get RAW, VOLTS
AISCAN
BUFOVERWRITE Set/Get ENABLE, DISABLE
BUFSIZE Set Set/Get
CAL Set/Get ENABLE, DISABLE
COUNT Get
EXTPACER Set/Get ENABLE/MASTER, ENABLE/SLAVE,
ENABLE/GSLAVE
HIGHCHAN Set/Get 0 to 7 single-ended, 0 to 3 differential
INDEX Get
LOWCHAN Set/Get 0 to 7 single-ended, 0 to 3 differential
(must be ≤ HIGHCHAN)
QUEUE Set/Get ENABLE, DISABLE, RESET
RANGE{ch} Set/Get BIP20V, BIP10V, BIP5V, BIP4V, BIP2PT5V,
BIP2V, BIP1PT25V, BIP1V
RANGE{element/ch} Set Element: 0 to 15
Channel: 0 to 7 single-ended, 0 to 3
differential
Range: see the range values above.
RATE Set/Get 0.596 Hz to 50,000 Hz (1 channel)
SAMPLES Set/Get 0 to N
(0 = continuous scan; N = 32-bit)
SCALE Set/Get ENABLE, DISABLE
START
STATUS Get IDLE, RUNNING, OVERRUN
STOP
TRIG Set/Get ENABLE, DISABLE
XFRMODE Set/Get BLOCKIO, SINGLEIO
AITRIG
Type Set/Get EDGE/RISING, EDGE/FALLING
REARM Set/Get ENABLE, DISABLE