Measurement Computing DAQFlex User Guide - Manual (Page 117)

DAQFlex Software User's Guide Hardware Reference – USB-2408 Series
117
Component Supported
Property/Command Set/Get Supported Values
AISCAN
BUFOVERWRITE Set/Get ENABLE, DISABLE
BUFSIZE Set/Get
CAL Set/Get ENABLE, DISABLE
COUNT Get
HIGHCHAN Set/Get 0 to 15 single-ended, 0 to 7 differential
INDEX Get
LOWCHAN Set/Get 0 to 15 single-ended, 0 to 7 differential
QUEUE Set/Get ENABLE, DISABLE
RATE Set/Get 2.5 Hz to 1102.94 Hz (1 channel)
RANGE
Set/Get
BIP10V, BIP5V, BIP2.5V, BIP1.25V,
BIP625.0E-3V, BIP312.5E-3V,
BIP156.25E-3V, BIP78.125E-3V
RANGE{ch}
RESET Set
SAMPLES Set/Get 0 to N
(0 = continuous scan; N = 32-bit)
SCALE Set/Get ENABLE, DISABLE
START Set
STATUS Get IDLE, RUNNING, OVERRUN
STOP Set
TEMPUNITS Set/Get DEGC, DEGF, KELVIN
XFRMODE Set/Get BLOCKIO, SINGLEIO
AO 1 Get Number of analog output channels
CAL Set/Get ENABLE, DISABLE
RES Get U16 (unsigned 16-bit integer)
SCALE Set/Get ENABLE, DISABLE
UPDATE Set
AO{ch}
1 OFFSET Get 4-byte floating point numeric
RANGE Get BIP10V
REG Set/Get 0 to 65535
SLOPE Get 4-byte floating point numeric
VALUE Set 0 to 65535
AOCAL
START Set
STATUS Get
AOSCAN
1 BUFSIZE Set/Get
COUNT Get
HIGHCHAN Set/Get 0 to 1
INDEX Get
LOWCHAN Set/Get 0 to 1
RESET Set
RATE Set/Get 1 Hz to 1000 Hz (1 channel)