Measurement Computing DAQFlex User Guide - Manual (Page 100)

DAQFlex Software User's Guide Hardware Reference – USB-200 Series
100
Component Supported
Property/Command Set/Get Supported Values
SAMPLES Set/Get 0 to N
(0 = continuous scan; N = 32-bit FIFO)
SCALE Set/Get ENABLE, DISABLE
START Set
STATUS Get IDLE, RUNNING, OVERRUN
STOP Set
TRIG Set/Get ENABLE, DISABLE
XFRMODE Set/Get BLOCKIO, SINGLEIO
AITRIG
SRC Set/Get HWSTART/DIG
Type Set/Get EDGE/RISING, EDGE/FALLING
LEVEL/HIGH, LEVEL/LOW
AO
1
Get 2
RES Get U12 (unsigned 12-bit integer)
SCALE Set/Get ENABLE, DISABLE
AO{ch}
1
RANGE Get UNI5V
VALUE Set 0 to 4,095
0 to 4.99838 when SCALE is enabled
CTR
Get 1
CTR{ch}
START Set
STOP Set
VALUE Get 0 to 4,294,967,295
Set 0 (resets the counter to 0)
DEV
FLASHLED/{n} Set 0 to 255
FWV Get MM.mm (M = major; m = minor)
ID Set/Get Up to 56 characters
MFGCAL Get yyyy-mm-dd HH:MM:SS
MFGCAL{item} Get YEAR as yyyy; 20xx
MONTH as mm; 01 to 12
DAY as dd; 01 to 31
HOUR as HH; 01 to 23
MINUTE as MM; 01 to 59
SECOND as SS; 01 to 59
MFGSER Get Up to 8 hexadecimal digits
RESET/{value} Set DEFAULT
DIO
Get 1
DIO{port}
Get 8
DIR Set/Get IN, OUT
LATCH Set/Get 0 to 255
VALUE Set/Get 0 to 255