Measurement Computing DAQFlex User Guide - Manual (Page 68)

DAQFlex Software User's Guide DAQFlex Message Reference – Programming messages – TMR
68
 Get the value of a port.
Message
"?DIO{port}:VALUE"
Response "DIO{port}:VALUE=value"
port The port number.
value The value of the port.
Example "?DIO{0}:VALUE"
 Set the value of a bit.
Message
"DIO{port/bit}:VALUE=value"
Response "DIO{port/bit}:VALUE"
port The port number.
bit The bit number.
value The value of the bit.
Example "DIO{0/1}:VALUE=1"
Note Performing an output operation on a programmable port that has not been configured
for output will generate an error.
 Get the value of a bit.
Message
"?DIO{port/bit}:VALUE"
Response "DIO{port/bit}:VALUE=value"
port The port number.
bit The bit number.
value The value of the bit.
Example "?DIO{0/1}:VALUE"
TMR
Sets and gets property values for a timer output channel.
Refer to the device-specific information in the Hardware Reference section for the component properties
and commands supported by each DAQ device.
Properties
DELAY, DUTYCYCLE, IDLESTATE, PERIOD, PULSE, PULSECOUNT, START, STOP
(Component only)
 Get the number of timer output channels on the device.
Message
"?TMR"
Response "TMR=value"
value The number of timer output channels.