Measurement Computing DAQFlex User Guide - Manual (Page 108)

DAQFlex Software User's Guide Hardware Reference – USB-1608FS-Plus
108
USB-1608FS-Plus
Use the components below to set or get device properties.
Component Supported
Property/Command Set/Get Supported Values
AI
Get 8
CAL Set/Get ENABLE, DISABLE
RES Get U16
SCALE Set/Get ENABLE, DISABLE
AI{ch}
OFFSET Get 4-byte floating point numeric
RANGE Set/Get BIP10V, BIP5V, BIP2V, BIP1V
SLOPE Get 4-byte floating point numeric
VALUE Get Unsigned integer numeric
VALUE/{format} Get RAW, VOLTS
AIQUEUE
CLEAR Set
COUNT Get 0 to 7 elements
AIQUEUE{element}
CHAN Set/Get element: 0 to 7
value: 0 to 7
RANGE Set/Get element: 0 to 7
value: BIP10V, BIP5V, BIP2V, BIP1V
AISCAN
BUFOVERWRITE Set/Get ENABLE, DISABLE
BUFSIZE Set/Get
CAL Set/Get ENABLE, DISABLE
COUNT Get
EXTPACER Set/Get ENABLE/MASTER, ENABLE/SLAVE,
DISABLE
HIGHCHAN Set/Get 0 to 7 single-ended
INDEX Get
LOWCHAN Set/Get 0 to 7 single-ended
QUEUE Set/Get ENABLE, DISABLE
RATE Set/Get 0.009 S/s to 100 kS/s
RANGE Set/Get BIP10V, BIP5V, BIP2V, BIP1V
Range{ch}
RESET
Set
SAMPLES Set/Get 0 to N
(0 = continuous scan; N = 32-bit FIFO)
SCALE Set/Get ENABLE, DISABLE
START Set
STATUS Get IDLE, RUNNING, OVERRUN
STOP Set
TRIG Set/Get ENABLE, DISABLE
XFRMODE Set/Get BLOCKIO, SINGLEIO, BURSTIO
AITRIG
TYPE Set/Get EDGE/RISING, EDGE/FALLING
LEVEL/HIGH, LEVEL/LOW