Measurement Computing DAQFlex User Guide - Manual (Page 112)

DAQFlex Software User's Guide Hardware Reference – USB-1608G Series
112
Component Supported
Property/Command Set/Get Supported Values
RESET Set
SAMPLES Set/Get 0 to N
(0 = continuous scan; N = 32-bit)
SCALE Set/Get ENABLE, DISABLE
START
STATUS Get IDLE, RUNNING, OVERRUN
STOP
TRIG Set/Get ENABLE, DISABLE
XFRMODE Set/Get BLOCKIO, SINGLEIO
AITRIG
REARM Set/Get ENABLE, DISABLE
TYPE Set/Get EDGE/RISING, EDGE/FALLING
LEVEL/HIGH, LEVEL/LOW
AO
1 Get Number of analog output channels
CAL Set/Get ENABLE, DISABLE
RES Get U16 (unsigned 16-bit integer)
SCALE Set/Get ENABLE, DISABLE
AO{ch} 1 OFFSET Get 4-byte floating point numeric
RANGE Get BIP10V
SLOPE Get 4-byte floating point numeric
VALUE Set BIP10V
AOCAL
START
STATUS Get
AOSCAN
1 BUFSIZE Set/Get
COUNT Get
EXTPACER Set/Get ENABLE, DISABLE
HIGHCHAN Set/Get 0 to 1
INDEX Get
LOWCHAN Set/Get 0 to 1
RANGE Get BIP10V
RATE Set/Get 1 to 500 kHz (1 channel)
SAMPLES Set/Get 0 to N
(0 = continuous scan; N = 32-bit)
START
STATUS Get IDLE, RUNNING, UNDERRUN
STOP
AOTRIG
REARM Set/Get ENABLE, DISABLE
TYPE Set/Get EDGE/RISING, EDGE/FALLING