Measurement Computing DAQFlex User Guide - Manual (Page 105)

DAQFlex Software User's Guide Hardware Reference – USB-1408FS-Plus
105
USB-1408FS-Plus
Use the components below to set or get device properties.
Component
Supported
Property/Command Set/Get Supported Values
AI
Get 8 (single-ended), 4 (differential)
CAL Set/Get ENABLE, DISABLE
CHMODE Set/Get SE, DIFF
RANGE Set/Get BIP20V, BIP10V, BIP5V, BIP4V, BIP2PT5V,
BIP2V, BIP1PT25V, BIP1V (differential
mode)
BIP10V (single-ended mode)
RES Get U14
SCALE Set/Get ENABLE, DISABLE
AI{ch}
OFFSET Get 4-byte floating point numeric
RANGE Set/Get BIP20V, BIP10V, BIP5V, BIP4V, BIP2PT5V,
BIP2V, BIP1PT25V, BIP1V (differential
mode)
BIP10V (single-ended mode)
SLOPE Get 4-byte floating point numeric
VALUE Get Unsigned integer numeric
VALUE/{format} Get RAW, VOLTS
AIQUEUE
CLEAR Set
COUNT Get 0 to 8 elements
AIQUEUE{element}
CHAN Set/Get element: 0 to 7 single-ended; 0 to 3
differential
value: 0 to 7 single-ended; 0 to 3
differential
RANGE Set/Get element: 0 to 7 single-ended; 0 to 3
differential
value: BIP20V, BIP10V, BIP5V, BIP4V,
BIP2PT5V, BIP2V, BIP1PT25V, BIP1V
(differential mode)
BIP10V (single-ended mode)
AISCAN
BUFOVERWRITE Set/Get ENABLE, DISABLE
BUFSIZE Set/Get
CAL Set/Get ENABLE, DISABLE
COUNT Get
EXTPACER Set/Get ENABLE, DISABLE
HIGHCHAN Set/Get 0 to 7 single-ended, 0 to 3 differential
INDEX Get
LOWCHAN Set/Get 0 to 7 single-ended, 0 to 3 differential
(must be ≤ HIGHCHAN)
QUEUE Set/Get ENABLE, DISABLE
RATE Set/Get 0.014 S/s to 48 kS/s