Marantz SR6006 - Manual (Page 75)

72
Connecting the RS-232C connector
When you connect an external control device, you can control this unit
with the external control device.
External serial controller
Perform the operation below beforehand.
q
Turn on the power of this unit.
w Turn off the power of this unit from the external controller.
e Check that the unit is in the standby mode.
Connecting the DC OUT (TRIGGER
OUT) jacks
When a device with DC IN jack is connected, the connected device’s
power on/standby can be controlled through linked operation to this
unit.
The DC OUT jack outputs a maximum 12 V/150 mA electrical signal.
12 V/150 mA trigger-compatible device
Set to change the conditions for linked operation via the DC OUT
1 or 2 jack.
“Trigger Out 1” or “Trigger Out 2” (
vpage 118 )
in Set as Necessary
NOTE
• Use the monaural mini-plug cable for connecting DC OUT jacks. Do
not use the stereo mini-plug cable.
• If the permissible trigger input level for the connected device is
larger than 12 V/150 mA, or has shorted, the DC OUT jack cannot be
used. In this case, turn off the power to the unit, and disconnect it.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion