Marantz SR6006 - Manual (Page 26)

23
STEP 4
Calculation
Set up speakers (Audyssey® Auto Setup)
10 Repeat step 9, measuring positions 3 to 8.
When measurement of position 8 is completed, a
“Measurements finished.” message is displayed.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
RETURN
Next Calculation
Retry
STEP3 Measurement (Finish)
Proceed to next (Calculation)
Enter Cancel
Measurements finished.
11
On the STEP 3 screen, use ui to select “Next →
Calculation”, and then press ENTER .
Measuring results are analyzed, and the frequency response of
each speaker in the listening room is determined.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6 STEP4 Calculation
Now calculating...Please wait.
20%
• Analysis takes several minutes to complete. The time required for
this analysis depends on the number of speakers connected.
The more connected speakers there are, the longer it takes to
perform analysis.
STEP 3
Measurement (2nd – 8th)
• In STEP 3, you will perform measurements at multiple positions (two
to eight positions) other than the main listening position.
• Just one position can be measured but measuring multiple positions
increases the accuracy of the correction of acoustic distortion within
the listening area.
9 Move the setup microphone to
position 2, use ui to select
“Measure”, and then press
ENTER .
The measurement of the second
position starts. Measurements can be
made in up to eight positions.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
RETURN
Next Calculation
Measure
STEP3 Measurement (2nd)
Start measurement. Output large test tone during measuring
Enter Cancel
Please place the microphone at ear
height at 2nd Iistening position.
If you want to omit measurements from the next position onward,
select “Next Calculation”.
(Go to STEP4 Calculation
)
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
Basic v
ersion
vSee overleaf