Registering preset codes – Marantz SR6006 User Manual
Page 127

124
Registering preset codes
When preset codes are registered in the included remote control unit,
it can then be used to operate any devices you have, such as DVD
players or TVs made by different manufacturers.
NOTE
• No preset codes other than
BD
,
DVD
,
SAT
and
TV
can be registered.
• In the factory settings, remote control codes for all marantz products
are registered.
n Buttons used for operating the devices
q
SOURCE
Z / X
For switching power of each device on or off.
w
uio
p
,
ENTER
For menu operation of each device.
e
MENU
,
SHIFT/TOP
MENU
For displaying the menu of each device.
r
3
,
1
,
2
,
8
,
9
,
6
,
7
t
Number button (
0
–
9
,
+10
)
y
PRESET +
,
PRESET –
u
TV
Z / X
,
TV INPUT
For operating a TV
This button is enabled in any mode.
For details on operation with the remote control unit, see pages
.
Registering preset codes
The following two methods can be used for registering the reset code.
q
Entering a 4-digit code
w
Scanning the code table
q
Entering a 4-digit code
See the preset code list table for the code to be input.
1
Press and hold down the input
source select buttons for the
appliance to control, and press
SET
until the SEND indicator
blinks.
2
Press the 4-digit code for the
appliance using
0
-
9
(code table
at the end of this book).
When the procedure is successful, the
LEARN indicator blinks twice.
NOTE
If the SEND indicator did not blink twice,
then repeat steps 1 and 2 and try entering
the same code again.
w
Scanning the code table
1
Switch the power of the
appliance to which you want to
register the preset code to ON.
2
Press and hold down the input
source select buttons for the
appliance to control, and press
SET
until the SEND indicator
blinks.
3
Aim the remote control at the
appliance and slowly alternate
between pressing
SOURCE
d
and
SOURCE
Z
/
X
for the appliance.
4
When the power of the appliance
that you want to register has
turned off, release the button.
5
Press
ENTER
.
When the procedure is successful, the
LEARN indicator blinks twice.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
vSee overleaf