Set up “channel select, Set up “channel select””) – Marantz SR6006 User Manual
Page 73
70
Set up speakers
6
Set up “Channel Select”
Use
ui
to select “Channel Select”, and then press
ENTER
.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the
recommendations in the manual,
Set the following items
If necessary.
Enable skip of measuring unused channels to reduce time
Enter
Cancel
Subwoofer
Surround Back
Measure
Measure (2 spkrs)
RETURN
Enter
Cancel
Measure subwoofer channel
Channel Select
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the
recommendations in the manual,
Set the following items
If necessary.
Enable skip of measuring unused channels to reduce time
Enter
Cancel
7
Use
ui
to select a channel.
Subwoofer Select for no subwoofers to be used. In this case, go
to step 8.
Surround
Back
Select the number of surround back speakers to be
used. In this case, go to step 9.
• “Surround Back” can be set when “Amp Assign” is
set to “NORMAL”.
8
Use
o
p
to set whether or not a subwoofer channel
is measured.
Measure Set for measuring a subwoofer.
Skip
Set for no measuring of a subwoofer.
9
Use
o
p
to set whether or not a surround back
channel is measured.
Measure
(2 spkrs) Set for measuring two surround back speakers.
Measure
(1 spkr) Set for measuring a surround back speaker.
Skip
Set for no measuring of a surround back speaker.
10
Press
RETURN
.
NOTE
After performing Audyssey® Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey® Auto Setup again.
4
Use
o
p
to select the
configuration of the connected
speakers.
NORMAL
Select the “NORMAL” setting to perform 7.1-channel
playback using the surround back, front height, or
front wide speakers.
ZONE2
Select the “ZONE2” setting to assign the unit’s built-
in power amplifier for ZONE2 and output the audio
in stereo.
ZONE3
Select the “ZONE3” setting to assign the unit’s built-
in power amplifier for ZONE3 and output the audio
in stereo.
SPKR-C
Select the “SPKR-C” setting to connect the front
speakers via the bi-amp connection.
F.Height
Select the “F.Height” setting to use the front height
speaker for playback.
F.Wide
Select the “F.Wide” setting to use the front wide
speaker for playback.
5
Press
RETURN
to exit the “Amp Assign” setting.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion