Leprecon LP-3000 Series - Manual (Page 51)

LP-3000 Users Manual
Chapter Four:
Presets
Introduction to Presets
LP-3000 Preset Panel
There are 18 faders in the lower section of the console. This section of the console
is called the Preset Panel. The LP-3000 stores in memory a complete stage scene,
called a “preset”, for each of the 18 faders. These presets operate in a “pile-on”
mode, allowing multiple presets to be up at any one time. Solo and Add Bump
buttons and an LED indicator are provided for each preset playback. The preset
playbacks of the LP-3000 have two Bump buttons. The preset Add and Solo
buttons are directly enabled by the Add Enable and Solo Enable switches.
The Preset Master fader, located on the master panel to the right of the X and Y
Crossfaders, controls the output level of all presets. An LED directly above it
indicates the level of the Preset Master fader.
The Page Roller located to the left of the preset Title Displays selects any of
twenty pages of playbacks that will be active when the console is in Run mode. The