Leprecon LP-3000 Series - Manual (Page 112)

108 Chapter Ten Advanced Moving Light Cue Programming
LP-3000 Users Manual
Programming Cues in Off-line Mode
There are several instances in which it is more convenient to program in off-line
mode:
•
When you have a list of cues and their properties.
•
When the LP-3000 is unavailable, such as when you’re traveling.
The procedures for programming cues in off-line mode are similar to those used
when programming on the LP-3000. The differences are highlighted in this section.
To Program a New Cue
1. Program a cue as you normally would.
2. When you are done, click Save As.
The LP-3000 displays the New Cue dialog box.
3. Accept the default name or enter the name of your choice.
Default names follow the pattern CUE_001, CUE_002 and so forth.
4. Click OK or press the ENTER key on the keyboard.
The LP-3000 saves the cue and all of its properties. You can leave the
properties as they are or edit them and save the cue.
To Create a Cuelist
The LP-3000 allows you to program cuelists that are not immediately tied to
playbacks.
1. If you are not at the Programmer screen, from the Main screen, click ML
Program.
The LP-3000 displays the Programmer screen.
2. If desired, click ML Attributes.
The LP-3000 displays the Programmer screen for attributes.
3. Click Cues.
The LP-3000 displays the Cue Settings screen.
4. Using the Scroll edgewheel, select the first cue for the cuelist.
5. Click Settings.
The LP-3000 displays the Cue Settings screen and shows the properties of
the cue that you selected in step 4.