Leprecon LP-3000 Series - Manual (Page 27)

LP-3000 Show Basics Chapter Two 23
LP-3000 Users Manual
3. Click OK.
If a show was already open, the LP-3000 asks you to confirm closing that
show before it creates the new one.
4. Click Yes.
5. Click OK.
The LP-3000 displays the Show screen.
To Open an Existing Show
1. From the Main screen, click Setup and then Show.
The LP-3000 displays the Show screen.
2. Using the Show edgewheel, select the show that you want to open.
3. Click Open Show.
NOTE: This button will not be available if you select the show that is
currently open.
The LP-3000 opens the show.
To Close a Show
1. From the Main screen, click Setup and then Show.
The LP-3000 displays the Show screen.
2. Using the Show edgewheel, select the show that is currently open.
3. Click Close Show.
NOTE: The Close Show button is available only when the show that is
currently open is selected in the Show Selection list.
To Copy a Show
There may be instances where it is convenient to use an old show as the starting
point for a new show. For example, you may plan to use the same lights and even
the same cues—changing only the focus positions—as the ones in a show that you
created previously. When this is the case, we recommend that you make a copy of
the old show and make your changes to the copy.
1. From the Main screen, click Setup and then Show.
The LP-3000 displays the Show screen.
2. Using the Show edgewheel, select the show that you want to copy.
3. Click Copy Show.
The LP-3000 displays the Copy Show dialog box.
4. Enter a name for the copy.
5. Click OK.