Hypertherm HD4070 Rev.1 - Manual (Page 176)

HyPerformance HD4070 Instruction Manual 5-13
MAINTENANCE
NEXT
PORT 0
00000000
PORT 2
00000000
PORT 1
00000000
PORT 3
00000000
PORT 8
00000000
PORT 10
00000000
PORT 9
00000000
PORT 11
00000000
PORT 12
00000000
PORT 14
00000000
PORT 13
00000000
PORT 4
00000000
PORT 6
00000000
PORT 5
00000000
PORT 7
00000000
NEXT
PORT 0
00000000
Bit 0-7
17
18
VOLTAGE: 0.0 V
STARTS: 0
ERRORS: 0
HOURS: 0000000.0
STATE:
AMPERAGE: 0.0 A
POWER CHECK: 000.0 V
INLET GAS 1: 0.0 PSI
INLET GAS 2: 0.0 PSI
INLET GAS 3: 0.0 PSI
DISPLAY REV: 0
DATA BASE REV: 0
SOFTWARE REV: 0
Service display screens
Screen 17 is display only. No adjustments can be made.
Amperage – Actual arc current
Power check – Actual measure of 120VAC from control transformer
Inlet gas 1 – Inlet gas pressure (not checked in idle state)
Inlet gas 2 – Inlet gas pressure (not checked in idle state)
Inlet gas 3 – Inlet gas pressure (not checked in idle state)
State – State of power supply
Screen 18 is display only.
Input/Output status: See table in Appendix D for details.
State 0 = Initialization State 6 = Arc transfer
State 1 = Waiting for user to select process State 7 = Ramp-up
State 2 = Purge State 8 = Steady (run) state
State 3 = Idle (waiting for start) State 9 = Ramp-down
State 4 = Preflow and IHS, if THC is present State 10 = Final ramp-down
State 5 = Pilot arc State 11 = Auto OFF
State 14 = Shut-down