Harken 3811 System A CB & Slider Battcar - Manual (Page 9)

System A (CB/slider) 9
1. Slip top track slugs into mast groove. Use 32 mm (1 1/4") mounting slug
for top stop.
2. One drop blue Loctite ® adhesive into each connector slug hole.
Mast up: Remove tape. Tighten screw to hold track.
CB System (Slug Mount) Install Track
Short top track lengths Top slug
41 mm (1 5 /
16
") 67 mm (2 5 /
8
")
52 mm (2 1 /
16
") 19 mm ( 3 /
4
")
Mast up: Tape 32 mm (1 1/4") slug even with top of upper track. Tape other
slugs in place.
Short top track lengths
41 mm (1 5 /
16
") Use one screw in stop
52 mm (2 1 /
16
") Use both screws
3. Thread 5 mm x 25 mm endstop screws through endstop, track, and into endstop slug.
Loctite is a registered trademark of Henkel AG & Company KGaA.