Harken 3811 System A CB & Slider Battcar - Manual (Page 11)

System A (CB/slider) 11
CB System (Slug Mount) Install Track
7. Hold full-length track piece up to mast. Loosely install top screw.
Use putty knife to slide additional slugs and connector slug into place. Loosely install all
fifteen 5 mm x 20 mm screws.
8. Slide tracks up enough to fit next track.
Mast up: Hold upper tracks. Loosen screw that holds tracks. Slide track up. If screws
bind in mast groove opening, loosen them untill track slides. Tighten new bottom screw
securely.
9. Repeat until full-length tracks installed.
10. Raise tracks so 203 mm (8") bottom
track fits.
11. Install screwpin endstop kit.
Note: If bottom full-length track blocks
feeder gap, load bottom track slugs before
installing track.
CAUTION! Do not let tracks drop. Severe injury to hands
and/or fingers can result.
3808, 3809, 3810 Endstop Kit
Leave bottom 203 mm (8") track
off untill cars are installed.