Harken 3811 System A CB & Slider Battcar - Manual (Page 13)

System A (CB/slider) 13
IMPORTANT! To keep balls captive we recommend loading cars onto track without sail installed.
Chart below shows correct number of balls for each car.
2. Load intermediate car (if used). Alternate with batten cars until all cars are
loaded.
Mast up: Use halyard to hold cars up.
1. Headboard cars: Hold car so cap screw head faces up. Align car on guide
section of loader track and gently roll onto upper tracks. If car sticks, realign
and roll onto track.
Tip: To load headboard car assembly, angle headboard coupler, roll car
onto track. If necessary, remove headboard assembly.
3. Install screwpin stop.
CB System Load Cars on Track
3808, 3809, 3810
Endstop kit
Remove bottom 203 mm (8")
track and install cars.
Tip: Use halyard to hold
tracks up.