Harken 3811 System A CB & Slider Battcar - Manual

Please read these instructions carefully before installing, servicing, or operating the equipment.
This manual may be modified without notice: www.harken.com/manuals for updated versions.
PLEASE SAVE THESE INSTRUCTIONS
BATTCAR INSTALLATION MANUAL
System A CB and Slider
Installation Manual – Intended for specialized personnel or expert users
4248 10/14
Introduction
Safety precautions 2
Preassembly (Slug Mount/Drill & Tap)
Parts 3
Tools 4
Sizing 4
Sail modifications
4
Track length (slug mount only) 4 - 5
Cutting top track to length (slug mount only) 6
Check fit of mounting slugs/cars (slug mount only) 7
Installation (Slug Mount)
Install track 8 - 10
Install screwpin endstop kit 10
Preassembly (Drill & Tap)
Parts 4, 11
Track length 11
Remove old track 11
Installation (Drill & Tap)
Drill, tap, and fasten 11
Operation (Slug Mount/Drill & Tap)
Load cars on track 12
Load cars on track with sail attached 13
Lost balls 13
Load cars on track with sail attached (slider) 14
Load sail on cars (CB/slider) 14 - 15
Maintenance (Slug Mount/Drill & Tap)
Removing sail 16
Car maintenance/cleaning/inspect 16
Lazy Jacks 16
Operating precautions 16
Sailmaker's Instructions (Slug Mount/Drill & Tap)
Dimensions 17
Installing headboard car assembly
17
Headboard plates 17
Battcars with batten receptacles 18 - 19
Distance between attachment points/reef points 20
Attaching sail to intermediate cars 21
Troubleshooting – Installation/Operation 22
Addresses 24