Harken 3811 System A CB & Slider Battcar - Manual (Page 16)

System A (CB/slider) 16
CB/Slider Systems Load Sail on Cars
4. Attach head of sail to headboard car with clevis pin and cotter pin.
3. Load toggle using 4 mm hex key and 8 mm wrench or nut driver. Tighten lock nut.
Do not over tighten. Make sure toggle can pivot.
2. Screw threaded stud to sail batten receptacle. Thread completely in and then back off
two turns. Receptacle must be allowed to rotate on stud.
4a. For 3881 and 3882 battcars, press quick release button and pushup on bottom of pin.
Remove clevis pin.
3a. For 3881 and 3882 battcars, line up toggle and insert clevis pin.