Harken 3811 System A CB & Slider Battcar - Manual (Page 10)

System A (CB/slider) 10
CB System (Slug Mount) Install Track
4. Slide slugs into place with putty knife.
Loosely install 5 mm x 20 mm screws.
Tip: Use putty knife to see if screws are loose enough to slide in groove.
Remember: Tracks may stick when reaching a spliced area on mast.
5. Loosen top screw. Slide top track up and position next 2.05 m (6'8 3/4") track.
Mast up: Tighten bottom screw to hold track.
6. Slide 15 mounting slugs and then the connector slug into mast groove.
Mast up: Tape in place.
One drop blue Loctite ® adhesive into each hole.
Loctite is a registered trademark of Henkel AG & Company KGaA.