Harken 3811 System A CB & Slider Battcar - Manual (Page 15)

System A (CB/slider) 15
3883 Reef Car Load Sail on Cars
1. Beginning with lower cars, use 4 mm hex key
and 8 mm wrench or nut driver to attach sail
to cars. Tighten lock nut until bottom tip
of fastener is flush with nut.
For 3883 reef car, line up plastic
becket spacer and insert clevis pin.
Slider System Load Cars on Track with Sail Attached
Slider cars can be loaded onto tracks with or without sail attached.
Line up car on guide portion of loader. Press car toward mast and
slide car onto track. Begin with upper cars and work down.
Tip: To load headboard car assembly, angle headboard. Roll car
onto tracks. If necessary, remove headboard assembly.

3883 reef car