Harken 3811 System A CB & Slider Battcar - Manual (Page 19)

System A (CB/slider) 19
CB/Slider—Battcars with Batten Receptacles—3830 CB/3803 Slider Sailmaker Instructions
Optional Shim
Use enclosed rubber shim so thin flat battens or small diameter round battens
fit correctly inside receptacle. To insert shim, take apart batten receptacle with
batten inside. Place rubber shim on one side of the batten. Assemble. Note:
screw and nuts are not captive.
Option 1
Round battens
End batten pocket 254 mm (10") from receptacle.
Flat battens
End batten pocket 254 mm (10") from receptacle.
Option 2
Round battens
Pucker batten pocket; draw edges together before inserting batten.
Flat battens
Fit batten into receptacle. If necessary, pucker batten pocket and
draw edges together before inserting. May require optional shim.