Grip Factory Munich GF-8 User Manual
Page 46
GF-8 Xten Crane System Instruction Manual
Page: 45
Attention:
The rigging system of the following Standard Versions need to be
assembled with different length of rigging connectors. Please see the
next paragraph below!
The rigging system has also to be assembled in a symmetrical way so
that the left and the right hand side of the cranes rigging systems has
the same parts at same positions.
Alignment of the rigging connectors for Standard Versions:
o
Xten-Versions 7 and 8:
Long Rigging Rod Connector:
Attach to Adjustable Rigging Rod Support and use to connect 3rd and
4th upper rigging rods.
Short Rigging Rod Connector:
Use to connect 5th and 6th upper rigging rods.
o
Xten-Versions 5 and 6:
Long Rigging Rod Connector:
Attach to Adjustable Rigging Rod Support and use to connect 3rd and
4th upper rigging rods.
Short Rigging Rod Connector:
not required.
o
Xten-Versions 4:
Short Rigging Rod Connector:
Use to connect 2nd and 3rd upper rigging rods.
Long Rigging Rod Connector:
not required.
o
Xten-Versions 3:
Short Rigging Rod Connector:
Attach to Adjustable Rigging Rod Support and use to connect 2nd and
3rd upper rigging rods.
Long Rigging Rod Connector:
not required.
Before operation, all locking pins, locking screws etc should be inspected to ensure
that all assembly sections are securely fastened.