Grip Factory Munich GF-8 - Manual (Page 15)

GF-8 Xten Crane System Instruction Manual
Page: 14
Version 6
(Pivot height 154cm / 5ft, Standard Rigging Harness, Rear Extension 127cm / 4’ 2”)
Front extension arms required 3 x 150 cm / 5’ + 100 cm / 3’ 3”
Rear extension arm required 1 x 127 cm / 4’ 2”
Lift range 891 cm / 31’ 10”
Maximum Euro-adapter height 675 cm / 22’ 1“
Lift capacity 80 kg / 176 lbs
Counterweight required for max. load 420 kg / 924 lbs
Counterweight required to balance empty arm 140 kg / 308 lbs
Crane weight (excluding dolly and weights) 199 kg / 437 lbs
Dolly weight 80 kg / 176 lbs
Arm reach (pivot to camera head mount) 663 cm / 21’ 8“
Length of rear end (pivot to outside of bucket) 220 cm / 7’ 2“
Rigging is required! Observe guidelines on page 41.
Continue from § 9, page 7
10. Connect one of the 150cm / 5’ sections to the middle section. Slip the connection
flanges into each other and secure them with the provided safety pin.
11. Connect another two 150cm / 5’ sections and a 100cm / 3’ 3” section to the first
150cm / 5’ section. Slip the connection flanges into each other and secure them with
the provided safety pins.
Note:
After each mounted section the support stand or rostrum can be moved up to
the next fixed section. We recommend to support longer crane versions with
more than one support stand or rostrum.
12. Connect the remaining angle adjuster to the end of the 100cm / 3’ 3” section and
secure it with the provided safety pin.
Attention: Pinch point
13. Mount the parallelogram rod support to the respective section as shown on page 40.
14. Connect three 150cm / 5’ parallelogram rods and a 100cm / 3’ 3” rod to the middle
section and in turn to the angle adjuster and secure the connections with the provided
safety pins.
15. Connect the remote bracket to the angle adjuster by inserting the male flange into the
female flange on the angle adjuster. Secure it with the safety pin.
16. Attach the weight bucket to the short end of the crane by inserting the male weight
bucket flange into the female flange on the angle adjuster. Secure it with the 2 safety
pins on the top of the angle adjuster.
Tip:
The angle adjuster has an integrated leveller. By turning it, the vertical plate
on the angle adjuster can be set to a perfect right angle. Correct setting of
the angle adjuster enhances the crane’s balance. Level the weight bucket,
the platform or the remote bracket before loading any weights.
17. Now the standard rigging system can be assembled. Therefor follow the instructions
as exemplary shown by version 17 and 18 on page 41.
Before operation, all locking pins, locking screws etc should be inspected to ensure
that all assembly sections are securely fastened.