Grip Factory Munich GF-8 - Manual (Page 43)

GF-8 Xten Crane System Instruction Manual
Page: 42
Make sure that the rigging is absolutely straight. For this case the Adjustable Rigging
Rod Support has to be adjusted in a proper way.
Attention:
The rigging system of the crane arm should be hand tightened
symmetrically from both sides of the crane in a way that the arm is
absolutely straight when carrying the loads of the counterweight
bracket, the platform or remote bracket.
Attention: The rigging system of the following Standard Versions need to be
assembled with different length of rigging connectors. Please see the
next paragraph below!
The rigging system has also to be assembled in a symmetrical way so
that the left and the right hand side of the cranes rigging system has
the same parts at same positions.
Alignment of the rigging connectors for Standard Versions:
o Standard-Versions 17 and 18:
Long Rigging Rod Connector:
Attach to Adjustable Rigging Rod Support and use to connect 2nd and
3rd rigging rods.
Short Rigging Rod Connector:
not required.
o Standard-Versions 6 to 8 and 14 to 16:
Short Rigging Rod Connector:
For version 7, 8, 15, 16 attach to Adjustable Rigging Rod Support and
use to connect 2nd and 3rd rigging rods.
For version 6 and 14 just use to connect 2nd and 3rd rigging rods.
Long Rigging Rod Connector:
not required.
Before operation, all locking pins, locking screws etc should be inspected to ensure
that all assembly sections are securely fastened.