Grandstream GXV3240 Administration Guide - Manual (Page 78)

Firmware Version 1.0.3.37 GXV3240 Administration Guide Page 76 of 117
Multicast Paging Video Codec
It is used to set the video codec for the multicast paging call. The
default setting is “H.264”.
Multicast Paging Image Size
It is used to set the video image size for the multicast paging call. This
list includes 720P, 4CIF, VGA, CIF, QVGA, and QCIF.
Multicast Paging Video Bit
Rate
It is used to set the video bit rate for the multicast paging call. The
default setting is “256 kbps”.
Multicast Paging Video Frame
Rate
It is used to set the video frame rate for the multicast paging call. This
list includes “15 frames/second”, “25 frames/second”, “30
frames/second”, and “Variable frames rate”.
Multicast Paging H.264 Profile
Type
It is used to set the H.264 codec profile type for the multicast paging
call. This list includes “Baseline Profile”, “Main Profile”, and “High
Profile”.
Multicast Paging H.264
Payload Type
It is used to set the H.264 codec payload type for the multicast paging
call. The default setting is “99”.
Multicast Listening Address
It is used to configure the IP address and port number for monitoring
multicast paging call. When the initiator initiates a call, answer the call
and display listening address and tag of the monitoring target. This
feature supports Video Multicast, when the initiator initiates Video
Multicast, it will automatically add the number 2 on the port of the
listening address. Reboot the phone to make changes take effect. The
valid IP address ranges from 224.0.0.0 to 239.255.255.255. Users may
also fill the label for each listening address corresponding to the
priority.
ADVANCED SETTING/MPK GENERAL SETTINGS
BLF Call-pick Prefix
It is used to configure the prefix prepended to the BLF extension if the
phone answers a call to the monitored party by the BLF key. The
default setting is ** for each account.
Event List URI
It is used to configure the event list BLF URI on the phone to monitor
the extensions in the list with MPK keys. This feature is based on
Broadsoft standard. It requires filling in the BLF ID to the box. For
example, if the server provides the URI: [email protected] , this
filed should be filled with BLF123. Then the monitored extensions will
be populated in the MPK app or Extension Board (if supported).
Force BLF Call-pickup by
Prefix
This is used to configure to always use the prefix for BLF Call-pickup.
The default setting is “No”.
Auto Provision Eventlist BLFs It is used to enable the Broadsoft Eventlist BLF keys auto provision