Grandstream GXV3240 Administration Guide User Manual
Page 61

Firmware Version 1.0.3.37
GXV3240 Administration Guide
Page 59 of 117
Standard: use AS format in session level; use TIAS format in
media level
Media Level: use AS format in media level
Session Level: use AS format in session level
None: no modifications in the session format
The default setting is "Media Level".
Note:
Please do not modify this setting without knowing the session format
supported by the server. Otherwise, it might cause video decoding
failure.
H.264 Payload Type
It is used to configure the H.264 codec message payload type format.
The default setting is 99. The valid range is from 96 to 127.
SRTP Mode
It is used to set if the phone system will enable the SRTP (Secured
RTP) mode. It can be selected from dropdown list:
Disable
Enabled but not forced
Enabled and forced
SRTP uses encryption and authentication to minimize the risk of denial
of service. (DoS). If the server allows to use both RTP and SRTP, it
should be configured as “Enabled but not forced”. The default setting
is "Disable".
SRTP Key Length
It is to configure all the AES (Advanced Encryption Standard) key size
within SRTP. It can be selected from dropdown list:
AES128&256 bit
AES 128 bit
AES 256 bit
If it is set to "AES 128&256 bit", the phone system will provides both
AES 128 and 256 cipher suite for SRTP. If set to "AES 128 bit", it only
provides 128 bit cipher suite; if set to "AES 256 bit", it only provides
256 bit cipher suite.
The default setting is “AES128&256 bit”.
Enable SRTP Key Life Time
It is used to configure whether to define SRTP key life time. When this
option is set to be enabled, during the SRTP call, the SRTP key will be
valid within 2
31
SIP packets, and phone will renew the SRTP key after
this limitation. The default setting is "Yes".
Silence Suppression
It is used to set the silence suppression/VAD feature. If it is set to "Yes",
when silence is detected, a small quantity of VAD packets (instead of
audio packets) will be sent during the period of no talking. If set to "No",