Grandstream GXV3240 Administration Guide - Manual (Page 66)

Firmware Version 1.0.3.37 GXV3240 Administration Guide Page 64 of 117
Note: When set "Special Feature" to "Baudisch Door System", 5
groups of door system URL and User ID will show up for users.

Baudisch Door System URL: This is used to input IP address or
URL of the system to make sure the account could identify the
call from door system.

Baudisch Door System SIP User ID: This is used to configure the
User ID of door system. Once configured, only the call from this
User ID would use door system while other calls use standard
mode.
Feature Key Synchronization
It is used for the Broadsoft standard call feature synchronization. If it is
enabled, the phone will send SIP SUBSCRIBE message to the server
and receive SIP NOTIFY message from the server to synchronize the
DND, Call Forwarding and Call Center features. The default setting is
"Disable".
Enable BroadSoft Call Park
It is used to configure whether to send SUBSRCIRBE message to
BroadSoft server to obtain Call Park notifications. The default setting
is “No”.
Enable Call Features
It is used to switch the local start command feature. If it is set to "Yes",
the feature will be enabled to recognize the local star code command.
Otherwise, it will be disabled. The default setting is "No".
No Key Entry Timeout (s)
It is used to define the expiration timer (in seconds) for no key entry.
The dialed digit will be send out if no other digits entered within the set
period. The default value is 4 seconds. The valid range is from 1 to 15.
This feature does not work if the dialer page is entered via the Account
Widget on the phone.
Ring Timeout (s)
It is used to define the expiration timer (in seconds) for the rings with
no answer. The default setting is 60. The valid range is from 10 to 300.
Virtual Account Group
It is used to set to categorize accounts in server mode groups The
accounts in the same group will be combined as one and the account
widget will display the Caller ID in the account with lowest ID. The
phone can answer any incoming calls to each account in groups. If
user makes an outbound call, the phone system will use the lowest ID
account by default. If the account fails or SIP INVITE message is
timeout, the phone system will failover to the next account in the group
with higher account ID. If all the accounts are not available in the group,
the phone system will traverse all the accounts in the group and notify
the end users the session is failed.
Transfer on 3-way Conference
Hang up
It is to set if the phone system will end the three way conference hosted
on it if it hangs up. If set to "Yes", the conference will be transferred