Grandstream GXV3240 Administration Guide - Manual (Page 77)

Firmware Version 1.0.3.37 GXV3240 Administration Guide Page 75 of 117
ADVANCED SETTINGS/TONE GENERATOR
Auto Config CPT by Region
This is used to configure whether to choose Call Progress Tone
automatically by region. If set to "Yes", the phone will configure CPT
(Call Progress Tone) according to different regions automatically. If set
to "No", you can manual configure CPT parameters. The default setting
is "No".
Call Progress Tones:
Dial Tone
Second Dial Tone
Ring Back Tone
Busy Tone
Reorder Tone
Confirmation Tone
Call-Waiting Tone
PSTN Disconnect Tone
These settings are used to configure ring or tone frequencies based
on parameters from the local telecom provider. By default, they are set
to the North American standard.
Frequencies should be configured with known values to avoid
uncomfortable high pitch sounds.
Syntax: f1=val,f2=val [,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the period
of silence. In order to set a continuous ring, OFF should be zero.
Otherwise it will ring ON ms and a pause of OFF ms and then repeat
the pattern. Up to three cadences are supported.
Call-Waiting Tone Gain
It is used to adjust the call waiting tone volume. Users can select "Low",
"Medium" or "High". The default setting is "Low".
Default Ring Cadence
It is used to define the ring cadence for the phone. The default setting
is: c=2000/4000.
ADVANCED SETTING/MULTICAST PAGING
Paging Barge
It is used to set the threshold of paging calls. If the paging call’s priority
is higher than the threshold, the existing call will be hold and the paging
call will be answered. Otherwise, the existing call does not be affected.
If it is set to Disable, any paging call will not be answered. The default
setting is “Disable”.
Paging Priority Active
It is used to determine if a new paging call whose priority is higher than
the existing paging call will be answered. If it is checked, this feature
will be enabled. The default setting is disabled.
Multicast Paging Codec
It is used to select the codec type for the multicast paging call. This list
includes PCMU, PCMA, G726-32, G722, and G729A/B.
Enable Multicast Paging
Video
It is used to enable the video feature to establish a multicast paging
call. The default setting is disabled.