Unitec interface – Gasboy CFN Series Unitec PC Interface User Manual

Page 18

Site Configuration

Unitec Interface

http://www.gasboy.com

· Printed in the U.S.A.

MDE-4695 CFN Series Unitec® PC Interface for Site Controller III Version 3.6 and Later · July 2010

CRIND

and Gilbarco

are registered trademarks of Gilbarco Inc. Tokheim

is a registered trademark of Tokheim Group S.A.S. Unitec

a registered trademark of Unitec Electronics. Wayne

is a registered trademark of Dresser Inc. Windows

, Windows NT

, and Windows XP

are registered trademarks of Microsoft Corporation.

It is possible to perform logging on two sessions simultaneously. For COM2, the file would
start at wash_log.200 following the same format as COM1.

If you restart the CAR WASH session, it continues to generate the log file from the last one
written. For example, if you quit during wash_log.123 with (Alt+X) and start over or restart
(Alt+R), and turn on file logging again, it will begin with wash_log.124.

If you want to capture an event, press Alt and R (then press F again if you want to continue
with logging which will start a new log file), then you can remove or copy the old file.

Unitec Interface

For each Unitec Interface, an argument file is required. These files are stored in the root
directory of the Site Controller. For SC III, the location is C:/SC3/XBIN. The Parameter file
extension begins with an “A”. Therefore, “UNITEC.A0x” is a valid parameter name.

Currently, there are no parameters that must be set in this file. Useful options may be added in
future versions.