Gasboy CFN Series Unitec PC Interface - Manual (Page 14)

Site Configuration Gate Configuration
Page 10 MDE-4695 CFN Series Unitec® PC Interface for Site Controller III Version 3.6 and Later · July 2010
Gate Configuration
Use the disk-based configuration program “GATE”, to view the configuration submenus for
the Car Wash information.
Gate SubMenus
The following is a list of the submenus currently available for the Gate and Gate Controllers.
1 = Gasboy Gates
2 = Gasboy Gate Controller
3 = Unitec Wash parameter
4 = Unitec Wash types
5 = Unitec Wash discounts
6 = Quit
Unitec Wash Parameters
Figure 4-1: Unitec Wash Parameters
# Description
1 Reader car wash prompt line 1: what type of wash
: 2 e n i l 2
: 3 e n i l 3
: 4 e n i l 4
5
Car wash price code: 0
6 Days carwash code valid: 0
------------------------------------------------------
Enter number of parameter to modify or q to quit:
To change the parameters of the Car Wash, select submenu 3, Unitec Wash Parameters from
the Gate menu.
The parameters you can configure in the Unitec Wash Parameters are as follows:
• Reader Car Wash prompt line 1 [What type of Car Wash]: Enter the first line of the
display. The default will be displayed between the brackets. Enter additional information
for lines 2 - 4, if required. This information will be displayed at the Card Reader.
• Price code for Car Wash prices [0]: The Car Wash driver uses this price code for all Car
Washes. Each Car Wash type uses the price level corresponding to its type. For example,
Car Wash type 42 will use price level 42 of the price code configured here. The price code
you assign here must be entered on the site using the Load Price command.
• Days Car Wash code valid [0]: The Unitec Car Wash Controller does not remove wash
codes from memory automatically. This must be done with a user command at the Unitec
console. The number of days listed here informs the customers how often you plan to clear
the Unitec memory.