Gasboy CFN Series Unitec PC Interface - Manual (Page 16)

Site Configuration Unitec Wash Discounts
Page 12 MDE-4695 CFN Series Unitec® PC Interface for Site Controller III Version 3.6 and Later · July 2010
Adding a Stock Number at the Profit Point Menu
To add a stock at the Profit Point menu, proceed as follows:
1 Select PLU Maintenance.
2 Select #1, Add an entry.
3 Select #2, Add a stock number.
4 Enter the same stock number that was entered above.
5 Enter the same department number that was entered above. Refer to “Adding a Car Wash
Product at the Site Controller Prompt” on page 9 .
6 Enter the retail price for this wash type. If price codes are used, this price must match the price
loaded with the LOad PRice command. Refer to
“Load the Price Code” on page 9 .
7 Exit the Profit Point menu as directed by the program.
Unitec Wash Discounts
To change the wash discounts, select submenu 5, Unitec Wash Discounts from the Gate
menu. The following information is displayed:
Figure 4-3: Unitec Wash Discounts
# Description
1 None
2 None
3 None
4 None
5 None
------------------------------------------------------
Enter number of discount to modify or q to quit:
Type of discount [0]: The currently supported discount types are:
0: Discount type disabled
1: Pumping of at least a given amount of fuel.