Gasboy M04230K00X - Manual (Page 26)

Installing the Pulser Kit in Single Unit
Page 26 MDE-4282B Gasboy Pulser Kits M04230K00X Installation • July 2005
Completing Assembly and Mounting Pulser Unit
1 In the kit, locate the following parts:
• 0469XX* Pulser and Coupling Assembly
• 056895 Spacer
• 056877 Spacer
• two 051806 screws
• two 068891 washers
• one 025015 elbow
• one 023939 conduit - bent pulser single
2 Feed the pulser and coupling assembly wires through the 025015 elbow and install the elbow
on the pulser and coupling assembly.
3 Install the 023939 conduit on the pulser and coupling assembly (to the elbow installed in
previous step).
4 Remove and discard two assembly screws and replace with the two spacers in positions shown
in the previous figure. Notice the difference in part numbers and positions of the spacers.
5 Place the pulser in position by positioning the conduit mounted on the pulser through the slot
in the unit. Ensure that the pinned shaft on the pulser aligns with the center hole in the idler
gear and the pin seats in the slot in the gear. The mounting holes in the mounting plate must
align with the holes in the spacers.
025015 elbows
023939 conduit
Pulser and
Coupling
Assembly
056895 spacer
056877 spacer
066400 union
025045 elbow