Gasboy M04230K00X User Manual
Introduction
MDE-4282B Gasboy Pulser Kits M04230K00X Installation • July 2005
Page 1
Introduction
This manual provides installation instructions for the Gasboy Pulser Kits M04230K001
through M04230K013. The kits and associated models covered in this manual are listed and
described in the
section.
Required Reading
Before installing a kit, the installer must read, understand, and follow:
• This manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• Applicable federal, state and local codes and regulations
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: This kit must be installed by a Gasboy Authorized Service Contractor (ASC) to ensure
warranty.
Required Tools
The following tools are needed to install the Pulser Kits:
• Wrench Set
• Flat tip screwdriver
• Cross tip screwdriver
• Punches (to remove and install pins)
MDE-4282B
Gasboy Pulser Kits M04230K00X Installation
July 2005
Document Outline
- Introduction
- Required Reading
- Required Tools
- Kit Identification
- Parts Lists
- M04230K001 - KIT-PLSR CX 9100QTW2, QXTW2 10:1
- M04230K002 - KIT-PLSR CC 9100QTW2,QXTW2 100:1
- M04230K003 - KIT PLSR 1:1 9100QTW2, QXTW2
- M04230K004 - KIT PLSR CX 9100Q, QX 10:1
- M04230K005 - KIT PLSR CC 9100Q, QX 100:1
- M04230K006 - KIT PLSR 1:1 9100Q, QX
- M04230K007 - KIT PLSR CX 9140Q, QX 10:1
- M04230K008 - KIT PLSR CC 9140Q, QX 100:1
- M04230K009 - KIT PLSR 1:1 9140Q, QX
- M04230K010 - KIT PLSR CZ 87Q 10:1 MONEY
- M04230K011 - KIT PLSR CZ 87QTW 10:1 MONEY
- M04230K012 - KIT PLSR 100:1 MONEY CM 87Q
- M04230K013 - KIT PLSR 100:1 MONEY CM 87QTW
- Important Safety Information
- Installing the Pulser Kit in Twin Unit
- Installing the Pulser Kit in Single Unit