Gasboy M04230K00X - Manual (Page 19)

MDE-4282B Gasboy Pulser Kits M04230K00X Installation • July 2005 Page 19
Installing the Pulser Kit in Twin Unit
Installing Drive Gear on Meter Computer Shaft
In the kit, locate two 043225 pins, two 031035 hubs, two 027401 gears, and two 049406
retaining rings.
1 On one of the computers, press a pin into the hole in the computer quantity shaft until it is
flush on one side of the shaft.
2 Place a hub on the shaft with the slotted portion of hub straddling the extending pin and align
hole in the hub with pin.
3 Push the pin through the hole in the hub until the pin is extending equally on both sides of the
hub.
4 Place a gear on the hub and align pin in the shaft with bearing slot in gear.
5 Secure gear in place by placing a retaining ring in the slot near the end of the shaft.
6 Repeat steps 1 through 5 on the shaft of the other computer.
Installing Plate and Idler Assembly
1 In the kit, locate two 053920 screws and two 027044 Plate and Idler Assemblies.
Note: The 053920 mounting screw for the Plate and Idler Assembly is a self-tapping screw.
Turning the screw into the mounting hole in the computer side frame and then removing
it without the assembly in place will make mounting the assembly easier.
2 At one of the computers, hold a Plate and Idler Gear Assembly in place and loosely secure
with the mounting screw. Boss and bracket holes in the computer align assembly for proper
gear meshing.
Note: This illustration is shown rotated 90 degrees from its installed position.
Retaining Ring
Hub
Pin
Computer
Shaft
Mounting
Screw
Plate and Idler
Gear Assembly