Gasboy M04230K00X - Manual (Page 21)

MDE-4282B Gasboy Pulser Kits M04230K00X Installation • July 2005 Page 21
Installing the Pulser Kit in Twin Unit
3 Repeat previous step for second pulser and coupling assembly.
4 Install the 023944 conduit on the front pulser and coupling assembly (the one with the black
band near the end of the wires) and the 023945 on the back pulser and coupling assembly.
Note: The front of the dispenser is the side with the junction box.The front pulser (mounts on
the left computer) is the one with the black band near the end of the wires.
5 On the left computer, remove and discard two assembly screws and replace with the two
spacers in positions shown in following figure. Notice the difference in part numbers and
positions of the spacers.
6 Place the front pulser (one with 023944 conduit mounted on it) in position (installs on the left
computer) by positioning the conduit mounted on the pulser through the slot in the unit
between the computers. Ensure that the pinned shaft on the pulser aligns with the center hole
in the idler gear and the pin seats in the slot in the gear. The mounting holes in the mounting
plate must align with the holes in the spacers.
7 Loosely secure in place with two washers and two screws.
8 After careful examination to ensure that the parts are meshed properly, tighten the screws.
9 Repeat procedures in Steps 2 through 5 for the second pulser and coupling assembly (installs
on the right computer).
Remounting the Computers
To remount the computers, proceed as follows:
1 At the side shaft mounting, turn the rotating wheel (on the computer) until the mark on the
wheel is pointing upward.
2 Mount the shaft on the computer and pin with pin saved during removal.
3 Mount the vertical shaft in the slot noted during removal (pin in shallow slots).
M056895 Spacers
M056877 Spacers