Fluke Biomedical DataSim 6100 - Manual (Page 63)

Maintenance, Service, and Calibration
Service and Calibration
3
3-5
Service and Calibration
If the new Simulator fails to operate successfully or if it needs a recommended
yearly calibration, contact the Fluke Biomedical Service Center immediately,
as indicated under Warranty and Product Support.
W Caution
To avoid damage to the Simulator or adverse affects on its
performance, a llow only qualified technical personnel to
service the Simulator.
Packing
If repairs or calibration are required, return the Simulator to the factory or the
nearest service center.
1. Before returning the Simulator for factory service, contact Fluke
Biomedical Service Center for a required Return Authorization Number.
2. Provide the following information:
• The Simulator serial number
• The specific steps that reproduce your problem
• A daytime phone number
• Your name / company
• A fax number (if available)
3. Pack the instrument carefully, using the original shipping container and
packing materials supplied by Fluke Biomedical. If the original packing
materials are not available, refer to Return Procedures for a list of
preferred materials or contact Fluke Biomedical for replacement packing.
Note
Failure to pack the instrument properly could void the warranty.