DNF Controls Universal Switch Panel (USP-8, USP-8D, & USP-16) - Manual (Page 19)

Universal Switch Panel (USP) User Manual 17 OF 41
15) Click on the Save button to save changes. Changes will take effect
immediately after saving.
OR,
Click on any other page button to exit without saving changes.
D. ALARM ASSIGNMENT
Use this page to create alarm groups for Tally Alarm Mode. A total of 32
tallies may be assigned to alarm groups. If Tally Alarm Mode is not used,
this page may be left blank. (This page is not available on USP-EM.)
Alarm Assignment Table Parameters
Parameter Description
Alarm # Alarm Group 1 thru 8
Priority Alarm priority within group, 1 thru 8. Highest= 1
Source Type Select tally source type:
Local GPI, Remote GPI, Remote GPO, or GTP32/DC20 Event
Remote
Device
Select Remote Device Description from list.
Source Value Select GPI or GPO number (1 thru 16).
If Source Type= GTP32/DC20, selection not available.
Label GTP32/DC20 Event Label. Event Label spelling must match the event label
on the remote GTP-32/DC20. (Only available if Source Type= GTP32/DC20.)
ON Text Text displayed when tally source is ON.
Text: Up to 18 ASCII characters (See ON Font selection below).
ON Font SMALL: Display 3 rows of 6 characters each. (Display 1st 18 characters)
NORMAL: Display 2 rows of 4 characters each. (Display 1st 8 characters)
BIG: Display 1 row of 3 characters. (Display 1st 3 characters)
ON Color Dark, Red, Green, or Amber (Flash and Blink not available)