DNF Controls Universal Switch Panel (USP-8, USP-8D, & USP-16) - Manual (Page 16)

14 OF 41 Universal Switch Panel (USP) User Manual
4) Select the TYPE of device to be controlled in the Type column.
5) If REMOTE USP or GTP32/DC20 was selected in the TYPE column, select the
Device Description in the Remote Device column. This is the remote device
controlled by the front panel switch.
6) Select the GPO (local or remote), in the GPO column, that will be controlled
by the front panel switch. A switch can control more than one GPO. Repeat
steps 2 – 5 for each GPO using the same switch number. When TYPE =
GTP32/DC20, GPO selection is not available.
7) Repeat steps 2 - 5 for each switch assignment.
8) Assign an ENABLE switch by selecting a switch number in the ENABLE
SWITCH box. Select NONE, if no ENABLE switch is required.
9) Disable all front panel switches by clicking on the DISABLE ALL SWITCHES
check box.
10) Click on the Save button to save changes. Changes will take effect
immediately after saving.
OR,
Click on any other page button to exit without saving changes.