DNF Controls Universal Switch Panel (USP-8, USP-8D, & USP-16) - Manual (Page 14)

12 OF 41 Universal Switch Panel (USP) User Manual
1) Click on the Remote Device Assignment button. The Remote Device
Assignment page will be displayed.
2) Click in the DEVICE Description field and enter a unique description/
identifier, up to 32 characters in length. This description/ identifier will
appear in the remote device list that is used on the other configuration pages.
3) Click in the IP ADDRESS field and enter the IP Address for this device.
4) Click on the down arrow in the Heartbeat Rate column and select the number
of seconds between heartbeats. For local LAN, use a small value. For WAN
or internet use a larger value.
5) Repeat steps 2) thru 4) for each remote device that the USP will communicate
with.
6) Click on the Save button to save changes. Changes will take effect
immediately after saving.
OR,
Click on any other page button to exit without saving changes.
NOTE- To clear a remote device assignment, set the IP address to 0.0.0.0 and
delete the Device Description.